Course title in Czech:
|Motor Vehicles Diagnostics|
|Course title in English: |
Motor Vehicles Diagnostics
|Semester: ||SS 2017/2018|
|Mode of completion and number of credits: |
Fulfillment of requirements (4 credits)
|Mode of delivery and timetabled classes: |
full-time, 2/1 (hours of lectures per week / hours of seminars per week)
part-time, 12/0 (lectures per period / seminars per period)
|Level of course: ||master continuing|
|Course type: |
|Type of delivery: ||usual|
|Mode of delivery for our mobility students abroad: |
-- item not defined --
|Language of instruction: |
|Course supervising department: ||Department of Technology and Automobile Transport (FA)|
|Institute of Lifelong Learning|
|Teachers: ||doc. Ing. Jiří Čupera, Ph.D. (examiner, instructor, lecturer, supervisor, tutor)|
|to study at faculty ICV|
|Timetable in this semester: |
-- item not defined --
Aim of the course and learning outcomes:
The course focuses on acquiring knowledge of theory and application of methods of technical diagnostics of motor vehicles and their respective assemblies, knowledge of diagnostic equipment and trends in diagnosis of motor vehicles. These skills are necessary for optimal decision making about the need and extent of repairs, to ensure efficiency and environmental performance of their operation and management of service and repair operations.
|1.||Diagnostic systems for vehicles. (allowance 2/2)|
|Terms and definitions of technical diagnostics.|
|b.||Objective and subjective methods of diagnostics.|
|Diagnostic systems, models and procedures.|
|Simple and branch diagnostic procedures related to a specific trouble, an optimal procedure for the use of available technical instrumentation.|
Diagnosis of gasoline engines, pollution measurement. (allowance 2/2)
Diagnostics of mechanical parts of engines.
Measurement of engine power, the results evaluation.
|Methods for determining the engine compression pressure.|
|The quality of the combustion process - the measurement of pollutants in exhaust gases.|
Diagnostics and adjustment of ignition systems and other electrical equipment. (allowance 2/2)
Diagnostics of conventional ignition.
|Methods of testing of electronic ignition systems.|
Oscillograms of primary and secondary ignition circuit.
|d.||Diagnostics of sensors and actuators in ignition system.|
Diagnostics of gasoline engine fuel systems. (allowance 2/2)
|Symptoms of malfunction in the fuel systems of gasoline engines.|
|Diagnostics of feedback mixture control.|
|Diagnosis of catalytic systems.|
|Diagnostic system for fuel strategy in operation conditions simulated on a chassis dynamometer.|
Readiness codes monitoring.
Functional testing of engine control systems.
|5.||Diagnostics and measurement of diesel engine emissions. (allowance 2/2)|
|a.||Diagnostics of mechanical parts of diesel engine.|
|Measuring procedures according to authorized institutions.|
|Evaluation of the combustion in a simulated load on a chassis dynamometer.|
|Engine power as a diagnostic parameter.|
|e.||Diagnostic systems reducing particulate matter.|
|6.||Diagnostics of diesel engine fuel system. (allowance 2/2)|
|Diagnostics of inline injection system.|
Diagnostics of plunger injection systems (axial, radial distribution).
Common Rail testing.
The PDE system testing.
|Compression test using functional test procedure of disabled injection.|
Diagnostics of hydraulic and pneumatic systems of vehicles. (allowance 2/2)
Diagnostics of air brakes and suspension systems of trucks.
Diagnostics of hydraulic clutch control systems.
|Diagnostics of hydro-pneumatic suspension.|
|Diagnostics of chassis and vehicle brakes. (allowance 4/4)|
|Diagnostics of mechanical chassis systems - axles, steering, brakes.|
Diagnostics of regulation of electric and electrohydraulic power steering.
|Chassis geometry adjustment.|
Wheels and wheel balancing.
|e.||Diagnostics of shock absorbers and suspension.|
|f.||Diagnostics of the brake system.|
|g.||Testing of brake support systems - ABS, ESP etc.|
Diagnostics of electronic systems used in vehicles. (allowance 2/4)
|Diagnostic procedures for actuators testing.|
|b.||Diagnostics of sensors and sensor clusters.|
Parallel diagnostics - signal simulation.
|Diagnostics of on-board networks - CAN-BUS, LIN etc.|
|e.||Disturbance in communication networks.|
On-board diagnostics. (allowance 2/2)
On-board diagnostics - OBD.
Protocols of on-board diagnostics.
|c.||Virtual system of on-board diagnostics.|
|Ecological and economic aspects of the diagnostics and future. (allowance 2/0)|
|Evaluation of economic efficiency of diagnostics.|
Environmental hazards of diagnostics.
|Learning activities and teaching methods: |
Type of teaching method
|laboratory work||4 h||4 h|
|consultation||0 h||12 h|
preparation for exam
|preparation for regular assessment||24 h||38 h|
|preparation for regular testing|
|preparation of presentation||6 h||6 h|
|elaboration and execution of projects||4 h||4 h|
|writing of seminar paper||10 h|
Elaboration of essay on a selected topic and its presentation.
The course is finished with oral exam. Requirements before oral exam: Active participation in at least 70% of class seminars and submission of all required homework (with passing grade). For passing oral exam student has to demonstrate at least 60% of requirement knowledes and skills. Circuits to exam are public and respect the content of syllabus.
Assessment criteria ratio:
|Daily attendance||Combined form|
|Recomended reading and other learning resources: |
VLK, F. Diagnostika motorových vozidel. Brno: František VLK, 2006.
|ČUPERA, J. -- ŠTĚRBA, P. Automobily. 1st ed. Brno: Avid, 2007. 195 p. ISBN 978-80-903671-9-7.|
Engine testing theory and practice. 3rd ed. Oxford: Burlington, MA, 2007. 442 p. ISBN 978-0-7680-1850-9.
|POŠTA, J. Operativní opravy strojů a zařízení. Praha: Ústav zemědělských a potravinářských informací, 1998. 45 p. ISBN 80-86153-79-7.|
POŠTA, J. et al. Opravárenství a diagnostika II: pro 2. ročník UO Automechanik. 1st ed. Praha: Informatorium, 2002. 183 p. ISBN 80-86073-88-2.
|POŠTA, J. et al. Opravárenství a diagnostika III: pro 3. ročník UO Automechanik. 1st ed. Praha: Informatorium, 2003. 187 p. ISBN 80-7333-017-2.|
|ŠTĚRBA, P. Autoelektronika: elektronické systémy ve vozidlech, jejich propojení, diagnostika, základní nastavení, seřízení a ovlivnění jejich funkce. 1st ed. Brno: Computer Press, 2010. 280 p. Rady a tipy pro řidiče. ISBN 978-80-251-2414-7.|
|Course listed in study plans for this semester: |
|Field of study C-TZEI-TZEI Technical expertise and engineering expertise, part-time form, initial period WS 2016/2017|
Field of study C-TZEI-TZEI Technical expertise and engineering expertise, full-time form, initial period WS 2016/2017
Course listed in previous semesters:
|SS 2019/2020, SS 2018/2019 (and older)|
|Teaching place: ||-- item not defined --|