Sylabus předmětu DMV - Motor Vehicles Diagnostics (FA - WS 2018/2019)


     ECTS sylabus          Sylabus          Rozvrh          


     Čeština          Angličtina          


Course title: Motor Vehicles Diagnostics
Semester: WS 2018/2019
Course supervisor: doc. Ing. Jiří Čupera, Ph.D.
Supervising department: Department of Technology and Automobile Transport (FA)
Time allowance: full-time, 2/2 (hours of lectures per week / hours of seminars per week)
Prerequisites for registration: Motor Vehicles or Machine Maintenance and Repair or Bachelor State Examination
Type of study: usual
Form of teaching: lecture, seminar
Mode of completion and credits: Exam (5 credits)
 
Course objective:
The course is focused on acquiring knowledge of theories and methods of application of technical diagnostics of motor vehicles and their respective assemblies, description of the diagnostic devices and diagnostic trends in motor vehicles. These skills are necessary for optimal decision-making about the need and extent of repairs to ensure the efficiency and environmental performance of their operation and management service and repair operations.
 
Course content:
1.Introduction to automotive diagnostics (allowance 1/0)
 
a.Diagnostics in various areas of human activity.

2.Diagnostic systems for vehicles. (allowance 2/2)
 
a.Terms and definitions of technical diagnostics.
b.Objective and subjective methods of diagnostics.
c.Diagnostic systems, models and procedures.
d.Simple and branch diagnostic procedures related to a specific trouble, an optimal procedure for the use of available technical instrumentation.

3.Diagnosis of gasoline engines, pollution measurement. (allowance 2/4)
 
a.Diagnostics of mechanical parts of engines.
b.Technical endoscopy.
c.Measurement of engine power, the results evaluation.
d.Methods for determining the engine compression pressure.
e.The quality of the combustion process - the measurement of pollutants in exhaust gases.

4.Diagnostics and adjustment of ignition systems and other electrical equipment. (allowance 2/3)
 
a.Diagnostics of conventional ignition.
b.Methods of testing of electronic ignition systems.
c.Oscillograms of primary and secondary ignition circuit.
d.Diagnostics of sensors and actuators in ignition system.

5.Diagnostics of gasoline engine fuel systems. (allowance 2/2)
 
a.Symptoms of malfunction in the fuel systems of gasoline engines.
b.Diagnostics of feedback mixture control.
c.Diagnosis of catalytic systems.
d.Diagnostic system for fuel strategy in operation conditions simulated on a chassis dynamometer.
e.Readiness codes monitoring.
f.Functional testing of engine control systems.

6.Diagnostics and measurement of diesel engine emissions. (allowance 2/4)
 
a.Diagnostics of mechanical parts of diesel engine.
b.Measuring procedures according to authorized institutions.
c.Evaluation of the combustion in a simulated load on a chassis dynamometer.
d.Engine power as a diagnostic parameter.
e.Diagnostic systems reducing particulate matter.

7.Diagnostics of diesel engine fuel system. (allowance 2/2)
 
a.Diagnostics of inline injection system.
b.Diagnostics of plunger injection systems (axial, radial distribution).
c.Injector testing.
d.Common Rail testing.
e.The PDE system testing.
f.Compression test using functional test procedure of disabled injection.

8.Diagnostics of hydraulic and pneumatic systems of vehicles. (allowance 2/2)
 
a.Diagnostics of air brakes and suspension systems of trucks.
b.Diagnostics of hydraulic clutch control systems.
c.Diagnostics of hydro-pneumatic suspension.

9.Diagnostics of chassis and vehicle brakes. (allowance 2/2)
 
a.Diagnostics of mechanical chassis systems - axles, steering, brakes.
b.Diagnostics of regulation of electric and electrohydraulic power steering.
c.Chassis geometry adjustment.
d.Wheels and wheel balancing.
e.Diagnostics of shock absorbers and suspension.
f.Diagnostics of the brake system.
g.Testing of brake support systems - ABS, ESP etc.

10.Vibrodiagnostics (allowance 1/1)
 
a.Signal analysis - the use of DFT and FFT.
b.Vibration - its analysis.
c.Acoustic signals.

11.Diagnostics of electronic systems used in vehicles. (allowance 2/2)
 
a.Diagnostic procedures for actuators testing.
b.Diagnostics of sensors and sensor clusters.
c.Parallel diagnostics - signal simulation.
d.Diagnostics of on-board networks - CAN-BUS, LIN etc.
e.Disturbance in communication networks.

12.On-board diagnostics. (allowance 2/2)
 
a.On-board diagnostics - OBD.
b.Protocols of on-board diagnostics.
c.Virtual system of on-board diagnostics.

13.Ecological and economic aspects of the diagnostics and future. (allowance 1/0)
 
a.Evaluation of economic efficiency of diagnostics.
b.Environmental hazards of diagnostics.

14.Innovation in diagnostics (allowance 1/0)
 
Teaching methods and workload (hours of workload):
Type of teaching methodDaily attendance
Direct teaching
     lecture24 h
     practice4 h
     laboratory work20 h
     professional educational excursion4 h
Self-study
     preparation for exam30 h
     preparation for regular assessment28 h
     preparation for regular testing16 h
     report from excursion, tour, practical placement18 h
     elaboration and execution of projects24 h
Total168 h
 
Key words:
diagnostics, diagnostic process, OBD, emissions
 
Course completion:
Credit is given for participation in seminars (80%) and writing semester project on a selected topic. The exam is in written and oral form. Students must answer 30 questions, and to meet the need is necessary to obtain at least 17 points out of 30 possible. After written test follows an oral examination.
 
Course methods: Lectures, demonstrations, practical exercises, consultations.
 
Reading list:
Basic:
VLK, F. Zkoušení a diagnostika motorových vozidel: výkon vozidla, brzdné vlastnosti, převodová ústrojí, řízení, geometrie kol, tlumiče a pružiny, řiditelnost a ovladatelnost, životní zkoušky, motor, zapalování, elektronické systémy. 2nd ed. Brno: František Vlk, 2005. 576 p. ISBN 80-239-3717-0.
RIBBENS, W. Understanding Automotive Electronics. Elsevier Science (USA), 2003. 470 p. ISBN 0-7506-7599-3.
DIETSCHE, K. -- REIF, K. Automotive handbook : Bosch - invented for life. Chichester: John Wiley, 2011. 1265 p. ISBN 978-1-119-97556-4.

Recommended:
ŠTĚRBA, P. -- ČUPERA, J. Autoelektronika. 1st ed. Brno: Computer Press, a.s., 2010. 280 p. ISBN 978-80-251-2414-7.
ČUPERA, J. -- ŠTĚRBA, P. Automobily - Diagnostika motorových vozidel I. 1st ed. Brno: Avid, s.r.o., Brno, 2007. 195 p. 7. ISBN 978-80-903671-9-7.
Pejša, L. a kol., Technická diagnostika, Praha: Skriptum ČZU, 1995 ISBN 80-213-0249-6

Study plans:
C-AS-AT Automobile Transport, full-time form, initial academic year WS 2017/2018
 
Run in the period of: WS 2019/2020, WS 2017/2018, WS 2016/2017, WS 2015/2016, WS 2014/2015, WS 2013/2014   (and older)
Course tutor: doc. Ing. Jiří Čupera, Ph.D. (examiner, instructor, lecturer, supervisor, tutor)
Teaching language: Czech
Town: Brno


Last modification made by Ing. Michal Karhánek on 02/12/2019.

Typ výstupu: